This in-line quick disconnect provides a quick, safe and easy way to incorporate a gas shut off in your draft beer system. With this beer fitting, no tools are required to connect or disconnect your air line. The disconnect locks into the place with an audible "click" to create a secure, leak-free seal. A simple thumb latch allows for easy, one-handed disconnections.
The quick disconnect features a high flow valve design for maximum flow in a compact coupling.
|Average Customer Rating:|
|(based on 1 reviews)|
|Great little fitting|
Oro Valley, AZ
|Comments:||When I bought a "Blichman Beer Gun" to fill bottles from my kegs, I needed 2 gas lines…one to the keg to dispense beer, & one to the beer gun to purge the bottled of sir before filling. My local homebrew store said the only way to do it was to use a splitter in my gas line and leave it in place all the time (not a good idea, since I use my spare CO2 tank to fill & sanitize kegs, too). They said I could another valve to swap for the one on my regulator when I needed to use the beer gun, but that seemed like too much of a hassle. Then I found these quick couplings, and they work great. I put the female one next to the valve on my regulator, and a male one on each of my beer gun setup and my basic keg hose. Now I can swap them at will. I just needed to buy a new Ball Lock gas valve.|
|Bottom Line:||I would recommend this product.|