Standard Double Gauge Co2 Regulator
 | This double gauge co2 regulator is designed for draft beer systems. This double gauge Co2 regulator has a forged brass body and a single metal gauge. This regulator features a non-adjustable safety blow off at 55-65 PSI, a flow control inlet nipple filter and a permanent Quad-Ring inlet seal on the primary gauge. |
You can use this regulator on any Co2 Tank with a CGA-320 valve. Co2 tanks have a male thread (CGA-320), these regulators have a female thread. Double Gauge Regulators Measure PSI, as well as the Volume of Co2 in the Cylinder. They are good for indicating how much Co2 is left in the cylinder and when you should have it refilled. The screw in the center is used to adjust the output pressure.
This double gauge Co2 regulator has a forged brass body and a single metal gauge. This regulator features a non-adjustable safety blow off at 55-65 PSI, a flow control inlet nipple filter and a permanent Quad-Ring inlet seal on the primary gauge.
- Forged brass and die cast for durability.
- Quad-Ring inlet seal at tank connection.
- Set screw pressure adjustment.
- Flow control inlet nipple filter.
- Type Primary Regulator - CO2
- Installation CO2 tank mount (CGA-320 threads)
- Performance 1 Pressure / 1 Keg
- Output Pressure Gauge 0-60 PSI, for accurate keg pressure
- Tank Pressure Gauge 0-3000 PSI, for remaining tank pressure
- Outlet Barb 3/8" O.D. (To fit 5/16" I.D. Gas Hose)
- Integral PRV For safety: pressure relief valve releases at 55-65 PSI
Standard Double Gauge Co2 Regulator Reviews
| Average Customer Rating: | (0) |
| (based on 0 reviews) |
| No customer reviews available. Be the first to write a review! |
Recommended Products:
 |  |  |  |
