Perfect for outdoor parties, camping trips, and tailgating, this Kegco Jockey Box lets you dispense ice cold beer without needing to keep the kegs themselves cold. Your beer is pumped into the jockey box and through a stainless steel coil submerged in ice water, cooling it down so that it comes out refreshingly cold on the other side. The 3/8" O.D. 120' stainless steel coil makes it far superior for cooling than "cold plate" style jockey boxes.
Constructed from a durable 54-quart family chest cooler, this single faucet jockey box features foam insulation for superior cold retention, and measures 16.5" H x 25" W x 19" D. Reinforced swing-up handles with a tie down loop feature make it easy to take on the go.
This jockey box comes with a chrome-plated brass faucet with brass lever, black plastic faucet knob, stainless steel shank, and ice box coupler assemblies. The faucet is mounted in the center of the cooler for easy access.
To complete your Jockey Box set up, you will need to add the following products if you do not already have them:
1. CO2 Tank
CO2 cylinders house the CO2 gas that is used to push beer from the keg through the beer line and out of the faucet. The bigger the tank, the more kegs you can dispense before needing to refill it. Generally speaking, it takes about a pound of CO2 to dispense a full size keg.
2. CO2 Regulator
A CO2 regulator helps you control the flow of gas from your CO2 tank to the keg. We have a wide variety of both single gauge regulators, which only display the CO2 output pressure, and dual gauge regulators, which display both CO2 output pressure and volume.
3. Air Line Assembly
The air line assembly (made up of one length of 5/16" blue air tubing and two plastic air line clamps) allows the CO2 to flow from the regulator into the keg, pushing beer out to the faucet. We have different lengths of air line to choose from.
4. Keg Coupler
Whether you plan on tapping an American D System keg or a European Import keg, you can choose from our selection of keg couplers to find the correct coupler to fit your needs.
5. Jumper Line Assembly
The jumper line assembly (made up of 5' of 3/8" Thermoplastic (Super Vinyl) beer tubing and your choice of wing nut or hex nut fittings) connects the top of the keg coupler to the inlet on the back of the jockey box. It is necessary to get the beer from the keg into the jockey box.
6. Flusher Line
The flusher line can be hooked up to a water spigot, allowing you to rinse the coil out with clean water to help keep it clean.
7. Cleaning Kit
For deep cleaning to remove the protein and mineral deposits that beer leaves behind, there is no substitute for a cleaning kit with beer line cleaner. The 5L Pressurized Cleaning Kit gives you enough pressure to easily clean the long draw of a coil. You can try using a hand pump system, but the resistance in the coil would make it a long, arduous process.
|Average Customer Rating:|
|(based on 1 reviews)|
|Took our parties to a whole new level.|
|Comments:||Just purchased and used it for the first time yesterday. The beer was so cold you almost needed gloves to hold your cup. After the line was full we got a perfect draw every time. This took our parties to a whole new level. The only negative is that it does not have a drain plug but it is not a big deal.|
|Bottom Line:||I would recommend this product.|