Perlick PERL Tarnish Free Brass Keg Beer Faucet - Stainless Steel

Conventional wisdom has no place at Perlick. That's because Perlick's drive for innovation is legendary, leaving convention for the other guys to play with. Now, wisdom in general... well, that's another story.

Perlick's new 630SSTF Stainless Steel Faucet with Tarnish Free Brass Exterior is a classic example. It has a revolutionary ball and floating front seal design that prevents beer from being exposed to air. As a result, the handle lever doesn't stick, and there is no build up of mold and bacteria in the faucet body. The 630SSTF also has fewer internal parts for better reliability.

WARNING: This product has Brass components. Brass alloys are known to contain trace amounts of Lead, which is known to the State of California to cause cancer and reproductive harm. For more information, go to www.P65Warnings.ca.gov.

• Stainless Steel construction - won't pit or tarnish, will not taint the flavor of the beer, and is also suitable for wine
• Patented forward sealing design eliminates the need for a valve shaft exposed to beer and air
• Spout angle is more vertical allowing a more thorough draining after each pour - no horizontal area for beer to collect
• Polished interior - smooth flow, less agitation and less foaming
• Easy to clean - may be cleaned in place

Follow these instructions if you need to take the faucet apart to replace worn parts.

Note: Anytime the Front Seat (I), O-ring (H) or Coupling Gasket(s) are removed, they should be replaced. Always use OEM replacement parts.

TO DISASSEMBLE:

1. If faucet is USED, soak faucet in warm cleaning solution for 1-2 minutes to free up bonnet and handle jacket. If the faucet is NEW, submerge the faucet in warm water for 5 seconds.
2. Unscrew and remove Jacket (1).
3. Unscrew and remove Compression Bonnet (2).
4. Remove Coupling Gasket (8) only if cut or worn.
5. To remove the Handle Lever Assembly (5A or 5B), lift it upward and push back.
6. To remove Front Seat (7) use a small screwdriver from the bonnet end of the faucet.
7. To remove O-ring (6) use a small screwdriver from the bonnet end of the faucet.
8. Inspect O-rings for wear or damage and replace as necessary.
9. To remove flow control lever, unscrew cap and pull out.
10. Remove flow control compensator from rear of faucet.

TO ASSEMBLE:

1. Re-install O-ring (6) into O-ring groove from bonnet end (use a small blunt screwdriver).
2. Re-install front Seat (7) into O-ring groove (use a small blunt screwdriver). Note: Seat must move freely in seat groove.
3. Re-install Handle Lever Assembly (5A or 5B).
4. Re-install Bearing Cup (4).
5. Re-install Bonnet Washer (3) into Compression Bonnet (2).
6. Re-install Compression Bonnet (2). Tighten by hand only. Do not use any tool, as this can damage the faucet.
7. Re-install Handle Jacket (1).
8. Re-install Coupling Gasket (8) if removed.
9. Install flow control compensator into rear of faucet and orientate so level engagement hole is facing lever insertion hole.
10. Install flow control lever, ensure pin on end of lever is aligned with compensator engagement hole and tighten cap.