We are open for business. Click here to read our Covid-19 Action Plan.

11 Feet of 3/16" I.D. (7/16" O.D.) Clear Beer Line with Hexnut Assembly

Regular Price: $13.74
You Save $2.75
Specify Model:

This beer line assembly comes standard with 11 Feet of 3/16" I.D. (7/16" O.D.) Clear Beer Tubing made of Themoplastic Vinyl Hose (Super Vinyl). This tubing meets and exceeds all rigid demands for beer dispensing. This beer line remains flexible and durable at recommended temperatures and pressures and will not rot, swell or dry out and is unaffected by normal cleaning compounds. This assembly comes with one Plastic Snap Clamp (reusable clamp design) and a Coupling Assembly of 1 Stepless Clamp, 1 3/16" Hose Nipple/Tail Piece and Hex Coupling Nut (connects to keg coupler).

Warning WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer and reproductive harm. For more information, go to www.P65Warnings.ca.gov.

11 Feet of 3/16" I.D. (7/16" O.D.) Clear Beer Line with Hexnut Assembly Reviews

Average Customer Rating:
(based on 13 reviews) 
No More Foam
by:Jeff (09-12-2019)
Crested Butte, Colorado
Comments:Being at elevation (8400’) advise from customer service to lengthen my beer lines was just the ticket! No more foam!!!!
Bottom Line:I would recommend this product.
Long enough to get the job done.
by:Floridakegerator (09-01-2019)
Tampa, Fl.
Comments:Good quality, no leaks. Plug and play.
Bottom Line:I would recommend this product.
Great Customer Service
by:Mike from the Cape (06-14-2018)
Cape Cod, MA
Comments:Customer Service was great, made sure I ordered the correct part and even answered questions after I received the part.
Bottom Line:I would recommend this product.
by:Billy Bob Jenkins (08-08-2017)
Comments:Installed in less than five minutes. Had a beer within 10.
Bottom Line:I would recommend this product.
Oh no! Oh wait, I like it
by:FuzzyRuttin (03-31-2017)
Syracuse NY
Comments:I bought these lines to replace the original lines that came with the Kegco dual-spout beer dispenser that I had purchased a couple/few years back. At first glance, the inner host diameter is visibly much smaller, like, my beer is gonna have the worst head ever.... but, no, in fact, it turned out to be completely opposite. Running the system at ~10psi, it pours wonderfully, even after first tap. It had always been somewhat of a challenge to find the sweet psi pressure setting with the old hoses, but someone must have done the necessary fluid dynamic calculations to get this right, because there hasn't been much fartin' around to get it right on my end.
Sorry, no measurements at hand to provide inner diameter comparisons before/after, just saying these lines seem to fit the bill. And I kept original length as delivered, no cutting.
Bottom Line:I would recommend this product.

Be the first to ask a question.