We are open for business, however our showroom is closed. Click here to read our Covid-19 Action Plan.

Rebuild Kit for Kegco 54 Series Regulators


The Kegco Regulator Rebuild Kit includes all the parts necessary to rebuild a Kegco 54 series regulator that has stopped functioning properly from extended use. Use this kit to have your old regulator working like new!

Rebuild Kit Components

Kit Includes:

  1. Jump Ring
  2. Spring Seat
  3. Adjusting Spring
  4. Diaphragm
  5. Valve Case nut
  6. Center Valve
  7. Big Nylon Washer
  8. Reverse Spring
  9. Safety Valve
Warning WARNING: This product has Brass components. Brass alloys are known to contain trace amounts of Lead, which is known to the State of California to cause cancer and reproductive harm. For more information, go to www.P65Warnings.ca.gov.

Rebuild Kit for Kegco 54 Series Regulators Reviews

Average Customer Rating:
(based on 3 reviews) 
Solved the pressure issue
by:Jim M (10-23-2017)
Windsor CO
Comments:Once I understood how this kit went into the diaphragm housing, everything went fine. Erica at Beverage Factory was great, took me to the large diagram on the web site which really helped.
The regulator worked fine once I corrected one mistake. Erica is also sending me a replacement high pressure gauge for the 542 regulator, even though it is over 5 yrs old. Very good customer service!!
Bottom Line:I would recommend this product.
by:3Sheets (10-04-2017)
Corpus Christi, tx
Comments:Fixed my regulator. Was easy to install.
Bottom Line:I would recommend this product.
All parts fit
by:William (11-18-2015)
Tampa FL
Comments:All of the parts fit inside the regulator. Shipped some parts I didn't have to replace which was a good thing. Only caution is make sure you tighten the cover back. Tighten it then test w soapy water. Wait then test again. If you don't it will leak all of you co2 out and be right back where you started.
Bottom Line:I would recommend this product.

Be the first to ask a question.