Kegco

Three-Way Kegerator Beer Gas / Air Distributor

Model:AD3
Regular Price: $33.74
You Save $6.75
$26.99

Kegco's Three-Way Air Distributor is the perfect solution for dispensing up to three different beer kegs at the same output pressure. Made of aluminum, the air distributor features one 3/8" O.D. inlet barb fitting that attaches to the CO2 regulator using 5/16" I.D. gas hose and three 3/8" O.D. outlet barb fittings that attach to the keg couplers using 5/16" I.D. gas hose. It also features two in-line shut offs and built-in mounting holes for convenient mounting.

  • Performance: 1 Pressure / 3 Keg
  • Manifold Material: Aluminum
  • Built-in mounting holes for convenient mounting
  • Inlet Connection: 3/8" O.D. (to fit 5/16" I.D. gas hose)
  • Outlet Connections: 3/8" O.D. (to fit 5/16" I.D. gas hose)
  • All connections are 1/4" NPT with right hand thread
Warning WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and reproductive harm. For more information, go to www.P65Warnings.ca.gov.

Three-Way Kegerator Beer Gas / Air Distributor Reviews

Average Customer Rating:
(5)
(based on 1 reviews) 
Wonderful product
by:Harley Gary (01-27-2017)
DFW, TX
Comments:My biggest concern was leakage. I tested it before install it in the new kegerator. Great! No leakage!
Bottom Line:I would recommend this product.
 
Loading.....
Question:
Do the outlets have check valves in them?
by CW on December 31, 2018
Answer:
They do not have check valves. Most keg couplers have a check valve to prevent liquid from going up into the gas line.
by Nick on January 02, 2019
Staff Answer
Question:
I have a 3 way kegerator I bought from beverage factory (hbk309x-3nk). I have this 3 way manifold but am not sure where to install it. Based on the way the kegs sit it appears the best location is on the chiller plate but not sure this is the recommended location. Where do you recommend installing this manifold for a 3 tap system? Thanks in advance for your help.
by Beer Guy on September 11, 2019
Answer:
Its up to you really, we dont recommend drilling screws into the wall to mount the air distributor. There is a good change you will hit a refridgerator line and destroy the unit. I recommend 3M stick tape with the velcro. Tap up along the wall or even to the top and it should hold the manifold to the wall, then when you want to pull it all out it can un velcro.
by Dave on September 13, 2019
Staff Answer