Wholesale Pricing Available. Apply Now
Cyber Week Savings! Deals up to 50% off!

Co2 Regulator Washer (nylon)

Model: 02H06-294
1 Reviews
$2.50SAVE 45% - $1.13
$1.38

90 Day Money Back Guarantee
IN STOCK (usually ships within 24 hours)
  • Reusable nylon plastic washer
  • Has grip edge to help keep washer in nut
  • Goes between the regulator and the Co2 tank
  • Please Note: May be red or white
DESCRIPTION
REVIEWS
Q&A

Reusable nylon plastic washer has grip edge to help keep washer in nut. Goes between the regulator and the co2 tank. May be red or white.

Warning Important information regarding Prop. 65 for CA residents.

08/21/2017

Buy at hardware store
Logan Pierson

It sure would be nice if this site would provide specs on the part.

This part is 45 cents. Not expensive. But cheapest shipping option to me is almost $12, and probably slow.

After using this part, I reassembled it again using parts at my hardware store. I was able to use a rubber quad-ring to get this to work. I believe it was 3/4 outer diameter. Fits perfectly within the hex nut with no clearance on the outside, and outside the inlet nipple with no clearance on the inside. Perhaps a male or U-Cup shaped O-Ring would work just the same with the ridges pointed toward the regulator and away from the CO2 tank, sealing the gap that allows the nut to slide back over the nipple.

Go to your hardware store and buy one of each for $1 and don't wait for shipping.

Be the first to ask a question.

CONNECT WITH US!

@BeverageFactory
Added to Cart

.....