Taprite T5752HP-05 Two-Product Primary Hybrid Regulator

This Taprite T752HP-05 2- Product Dual Pressure Hybrid Beer and Soda Co2 Regulator allows you to tap two kegs, one beer and one soda, at the same time and individually control the pressure to each keg! The regulator has a large hand control which makes it easy to adjust the pressure inside the keg. This regulator allows you to set the pressure for two different kegs that are being dispensed from one CO2 tank.

• Allows you to tap two kegs at the same time and individually control the pressure to each keg!
• Features a 0-60 gauge for beer, 0-120 for the soda and 0-2000 gauge for the input from the CO2 tank
• Large knobs allow easy pressure adjustment without requiring additional tools
• Lightweight polycarbonate bonnet is durable and will not corrode in wet environments
• Individual shut off valves allow you to switch each CO2 line on or off

The regulator has two separate regulator bodies that individually measure the pressure to each keg, 0-60 gauge for beer and 0-120 for the soda, this allows you to adjust each side of the regulator to the beverage you are dispensing. A third gauge (left gauge) shows you the pressure from the CO2 tank, so you know when you run out. Individual air shut off valves allow for each CO2 line to be turned on/off independently. Preset safety pressure relief valve automatically releases at 55-65 PSI for the beer and 150-160 PSI on the soda.

The lightweight polycarbonate bonnet is durable and will not corrode in wet environments. No special tools are required to raise or lower the CO2 pressure. The easy to use cap knob simply pulls out to adjust pressure up or down then pushes back in to lock in pressure.

Dimensions: 9"W x 7 1/2"H x 5 1/2"D

WARNING: This product has Brass components. Brass alloys are known to contain trace amounts of Lead, which is known to the State of California to cause cancer and reproductive harm. For more information, go to www.P65Warnings.ca.gov.