VintageView 4-Bottle BIG Series Wine Rack - Black Satin Finish

With VintageView wine racks the size of your wine collection is secondary - whether modest or extensive, these wine racks adapt to nearly any size wine storage area. The BIG Series Wine Rack holds four 3 to 6 liter wine bottles. This black is a powder coat and has a soft appearance. It is less shiny than a semi-gloss finish.

With VintageView wine racks the size of your wine collection is secondary - whether modest or extensive, VintageView wine racks adapt to nearly any size wine storage area. VintageView wine racks have been installed inside cupboards and cabinets, under stairways, over doorways, and in many other unique places.

The BIG Series Wine Rack holds four 3 to 6 liter wine bottles. The metal wine rack is available in Wine Bottle Green, Black or Nickel finish.

• Bottle Capacity: 4 (4 Rows x 1 Bottle Deep)
• Dimensions: 28"H x 8.25"D

• Bottle Capacity: 4 (4 Rows x 1 Bottle Deep)
• Dimensions: 28"H x 8.25"D
• Find the right bottle quickly
• Creates a gallery of wine label artwork
• Costs less than custom racking systems
• Scalable capacity - holds as little as a few bottles and up to many thousand
• Fits where no other wine storage system will
• Easy to Install
• Each rack contains: 1 base (heel) strip, 1 neck strip, and end caps on wall strip, 1 connector for stacking mounting hole covers and soft plastic rod tips
• These racks can be cut to any length or stacked on top of each other. Call us at 1-800-710-9939 for custom cutting.
• These racks are desgined to be attached to a wall or Floor to Ceiling Frame (FCF).
• Allow 2" above the top of the wall strip to make adequate room for the top bottle on the rack
• There are six pre-drilled mounting holes for fasteners on each set of racks, three holes per side - neck and base. Each fastener must support less than 20 pounds, of which most is in shear force (vertical pressure down on the wall). The top fastener has the most pull out force (horizontal pressure away from the wall). When installing wall strips always make sure the top fastener is solid.
• Recommended Fasteners for Installation
  1. Wood: Wood #8 x 2" wood screw
  2. Drywall over plywood: Drywall over plywood #8 x 1 1/2" wood screw
  3. Drywall: Drywall spiral insert (e.g. E-Z Ancor), Toggle bolt or Molly for top hole
  4. Concrete: Concrete 3/16" x 1 3/4" Masonry screw (e.g. Tapcon)
  UPC: 893297001252